Product Documentation
Abstract
IBM System x3655 - Heat sink filler removal movie
Content
Text from the audio portion of the heat sink filler removal movie
To remove a heat sink filler
Turn off the server and peripheral devices, and disconnect all power cords and external cables.
Remove the top cover:
- Rotate the top cover release latch up and slide the cover approximately one-half inch to the rear.
- Lift the cover off and place it aside.
Remove the riser card assembly:
- Press the two retention latches on the riser-card assembly toward the processor two socket then grasp the assembly at the rear and side edges and lift it from the server.
Remove the heat sink filler:
- Rotate the heat-sink release latch to the fully open position and pivot the heat sink filler up to disengage the tab on the heat sink filler from the slot in the heat sink retention bracket and lift the heat-sink filler out of the system.
For specific instructions for the removal and installation of hardware.
Document Location
Worldwide
[{"Type":"HW","Business Unit":{"code":"BU016","label":"Multiple Vendor Support"},"Product":{"code":"HW323","label":"System x->System x3655"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Line of Business":{"code":"","label":""}}]
Was this topic helpful?
Document Information
Modified date:
24 January 2019
UID
ibm1MIGR-5071706