Drive in bay 1 or 2 installation movie - IBM System x3200

Content

• Movie player help

Text from the audio portion of the drive installation movie

To install a drive in bay 1 or 2

1. Place the drive retainer clip on the side of the drive using the screw holes for alignment.
2. Slide the drive into the bay until latched in place.
3. Connect the signal and power cables to the drive.

1. Insert the two hinge tabs on the right side of the upper bezel into the slots in the chassis then rotate the bezel until secured in place.

1. Insert the two tabs at the bottom of the lower bezel into the slots in the chassis and then rotate the top of the lower bezel toward the server until it latches in place.

1. Position the cover over the ledge on the bottom of the chassis.
2. Rotate the cover toward the server until secured by the latch.
3. Lock the cover if required.
   

• Problem Determination and Service Guide