Product Documentation
Abstract
Instructions for removing the memory card from any xSeries 366 and xSeries 460 server.
Content
Text from the audio portion of the memory card removal movie
To remove a memory card:
Remove the top cover:
- Lift the cover-release latch handle.
- The cover slides to the rear, approximately one-half inch.
- Open release latch 1. Then, open release latch 2 and pull the card from the server.
- Place the card on a static-protective surface.
Note: If memory mirroring is enabled, you can hot-replace one memory card at a time on each memory power bus.
- The memory hot-swap enabled LED indicates that hot-swap memory is enabled.
- The error LED indicates that a DIMM has failed.
- The memory port power LED turns off to indicate that power has been removed from the port and you can replace a failed DIMM.
To remove a DIMM:
Open the retaining clip on each of the DIMM and lift the DIMM out of the connector.
Document Location
Worldwide
[{"Type":"HW","Business Unit":{"code":"BU016","label":"Multiple Vendor Support"},"Product":{"code":"HW20Y","label":"Older System x->xSeries 366"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Line of Business":{"code":"","label":""}},{"Type":"HW","Business Unit":{"code":"BU016","label":"Multiple Vendor Support"},"Product":{"code":"HW21J","label":"Older System x->xSeries 460"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Line of Business":{"code":"","label":""}}]
Was this topic helpful?
Document Information
Modified date:
24 January 2019
UID
ibm1MIGR-62932