Product Documentation
Abstract
Procedures for installing memory dimms from the eServer 325.
Content
Text from the audio portion of the installing memory movie
To install a DIMM:
Install the DIMM in the slot:
- Open the retention latches and insert the DIMM straight into the slot, pressing down on both corners of the DIMM at the same time.
- The side of the DIMM with the gold-edge connectors has an index slot, offset from the center of the DIMM. Align the index slot with the slot on the system board.
- Make sure that there is no gap between the DIMM and the retaining clips. If there is a gap, remove the DIMM; then, reinsert it correctly.
To install the cover:
Position the cover on the chassis, and close the latch.
For specific instructions for the removal and installation of hardware.
Document Location
Worldwide
[{"Type":"HW","Business Unit":{"code":"BU016","label":"Multiple Vendor Support"},"Product":{"code":"HW20C","label":"Older System x->eServer 325"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Line of Business":{"code":"","label":""}}]
Was this topic helpful?
Document Information
Modified date:
23 January 2019
UID
ibm1MIGR-53841