Memory removal and installation movie - IBM BladeCenter HS20, HS40, LS20

Content

• Movie player help

Note: Your system may differ slightly from the system shown in the movie above.

Text from the audio portion of the memory removal and installation movie

To remove an HS20 Blade:

1. Shut down the operating system and power off the blade.
2. Wait 30 seconds for the disk drive to spin down.
3. Squeeze the latches to release the handles, then rotate the handles to the open position, slide the blade out and place it on an ESD mat or flat non-conductive surface.

To remove the HS20 Blade cover:

1. Press in the cover tabs to release the latches, and then rotate the cover up and lift it off.

To remove a DIMM:

1. Release the latches and then lift the DIMM out of the connector.
2. Place it on the ESD mat.

To install a DIMM:

1. Ensure that the latches are in the open position.
2. Press the DIMM into the connector until the latches secure it.

To install the HS20 Blade cover:

1. Position the cover hinges over the pins in the blade chassis, and then rotate the cover down until the latches secure it.
   Here is a closer look at the hinge and pin action.

To install an HS20 Blade:

1. Slide the blade in and then close the latches simultaneously until secured by the latches.

View detailed installation and removal instructions:

• IBM BladeCenter HS20 (Type 8678) - Hardware Maintenance Manual and Troubleshooting Guide
• IBM BladeCenter HS20 (Type 8832) - Hardware Maintenance Manual and Troubleshooting Guide
• IBM BladeCenter HS40 - Hardware Maintenance Manual and Troubleshooting Guide
• IBM BladeCenter LS20 - Hardware Maintenance Manual and Troubleshooting Guide