Product Documentation
Abstract
Adapter support bracket removal and installation movie for the IBM eServer xSeries 235
Content
Text description of the adapter support bracket removal
Note: The air baffle assembly and all full-length adapter cards must have been removed for this procedure.
Open the adapter retention clip, and then lift out the plastic dividers. Disconnect the center fan cable from the system board. Press the release tab on each adapter support bracket latch, and then lift the adapter support bracket up and out of the system. Disconnect the cable from the card. Here's a closer look at a plastic channel latch action.
Text description of memory DIMM installation
Connect the cable to the card. Slide the adapter support bracket into the plastic channels. Press down until the adapter is secured with the two latches. Connect the cable to the system board. Install the plastic dividers. Close the adapter retention clip. Here's a closer look at the plastic divider hinge tab and the chassis slot.
Document Location
Worldwide
Was this topic helpful?
Document Information
Modified date:
24 January 2019
UID
ibm1MIGR-52004