Product Documentation
Abstract
Removing an I/O board Remove the top cover. Remove the I/O function card (1) and the Advanced System Management PCI Adapter (2). Remove any other adapters in the system. Disconnect all cables. To remove the I/O function card: Disconnect
Content

| Removing an I/O board |
|---|
- Remove the top cover.
- Remove the I/O function card (1) and the Advanced System Management PCI Adapter (2). Remove any other adapters in the system. Disconnect all cables. To remove the I/O function card:
- Disconnect all cables from the I/O function card.
Note: Carefully where each cable is connected before you remove it.
- Remove the two screws located on the metal connector plate inside the server.
- Remove the I/O function card retention bracket on the right side of the card by pulling out the fastener on the bracket.
- Carefully grasp the I/O function card by its top edge and pull the I/O function card out of the server.
- Place the I/O function card connector side up on a flat, static-protective surface.
- Disconnect all cables from the I/O function card.
- Remove all insulators (3).
- Remove the I/O board protector shield (5) covering the I/O board (7).
- Remove VRMs (4) from their slots on the I/O board.
- Unscrew the 14 screws -6-securing the I/O board to the I/O housing (8).
- Reverse the procedure to install the I/O board into the server.
Document Location
Worldwide
[{"Type":"HW","Business Unit":{"code":"BU016","label":"Multiple Vendor Support"},"Product":{"code":"HW18W","label":"Older System x->xSeries 370"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Line of Business":{"code":"","label":""}},{"Type":"HW","Business Unit":{"code":"BU016","label":"Multiple Vendor Support"},"Product":{"code":"HWN07","label":"Older System x->Netfinity 8500R"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Line of Business":{"code":"","label":""}}]
Was this topic helpful?
Document Information
Modified date:
24 January 2019
UID
ibm1MIGR-45629