HC94056: SKETCHER / PERFORMANCE / ISOLATE OPERATION ON A SKETCH GEOMETRY PROJECTED FROM A 3D WIRE FRAME IS TOO SLOW

APAR status

• Closed as program error.

Error description

• Problem:
  Isolating sketch geometry projected from 3D wire-frame is
  very slow.
  .
  Scenario :
  ---------
  1- Open in Catia the .CATpart
  2- Create a sketch on YZ plane
  3- Use PROJECT 3D ELEMENTS fonction to project all wireframe
  (132 elements)
  4- Use INSERT-OPERATION-3D GEOMETRY-ISOLATE to isolate the
  sketch geometry.
  --> Catia takes around 30 seconds to isolate 132 elements.
  .
  Expected Behaviour
  ------------------
  We need Catia to isolate groups of 4 000 elements with in a
  reasonable time (less than a minute)
  

Local fix

Problem summary

•  INCIDENT DIAGNOSIS:
  Performance problem during an Isolate operation
   of lots of elements (130)
  .
   TECHNICAL EXPLANATION FOR THE CORRECTION:
  Bad management of the modificationof the objects that are
   already in CSO.
  .
   ANSWER AND POSSIBLE BY-PASS:
  Problem is corrected : CPU time decreased from 46s to 6s.
  

Problem conclusion

• THIS PROBLEM WILL BE FIXED ON
    CATIA VERSION 5 RELEASE 10 GA level.
  NOTE THAT THIS PROBLEM WILL ALSO BE FIXED ON V5R9SP02.
   NOTE THAT THIS PROBLEM WILL ALSO BE FIXED ON V5R8SP07.
   .
  Comment: problem is also fixed on V5R9 SP01.
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Modules/Macros

•    FILE
  

Fix information

• Fixed component name

  CATIA V5 NT_INT

• Fixed component ID

  569151000

Applicable component levels

• R508 PSN SP50807

     UP02/09/06 N 1000

• R509 PSN SP50902

     UP02/08/20 N 1000