HC89604: A NON SHARP EDGE IS DETECTED WHEN UPDATING A FILLET: IN FACT, THE SELECTED EDGE IS NOT THE CORRECT ONE

APAR status

• Closed as program error.

Error description

• Start a V5 session:
  . File.Open the associated V4 model
  . Edit.Copy *MASTER
  . File.New Part
  . Edit.Paste Special as Specs
  . Update
    > EdgeFillet.1 ($FILL2): select a sharp edge
                                                                 .
  Comparing the erroneous edge in the V5 session, and the
  corresponding one for the V4 fillet, it appears that the
  selected edge in V5 is not the correct one.
  The same problem exists for Edgefillet.2.
  It is necessary to edit manually the definition of the
  Edgefillets to correct the fillet support edges.
  

Local fix

Problem summary

• Error when retrieving edge when trying to build a fillet
  after a solid model is migrated to a V5 part.
  

Problem conclusion

• THIS PROBLEM WILL BE FIXED ON
    CATIA VERSION 5 RELEASE 9 GA level.
                                                                 .
  The programming error is now corrected, and so the retrieved
  edge is correct, no message is issued.
  BUT for this particular model, the fillet propagation mode
  appaers as incorrect: minimal instead of tangent. The generated
  fillet is there not correct.
  This point is under study in the scope of a more important
  action which is not targeted for Release 9.
  Anyway, it is always recommended to migrate V54 solids into
  smart solids before migrating them.
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Modules/Macros

•    FILE
  

Fix information

• Fixed component name

  CATIA V5 NT_INT

• Fixed component ID

  569151000

Applicable component levels

• R507 PSN

     UP

• R508 PSN

     UP