HC84879: SKETCHER SPLINE POINTS COLOR IS NOT RESTAURED AFTER UNDO..

APAR status

• Closed as program error.

Error description

• Scenario:
  1. File open sent Part
     ---> A isoconstraint spline (green) is displayed in Sketch.1
  2. Modify Sketch.1/Constraints/Offset.10 from 40mm to 10mm
     ---> Spline and control points becomes red
  3. Select UNDO button twice.
  ===> Spline becomes green again but control point are still red.
  

Local fix

Problem summary

•  Spline control points color is not restored after a undo
  command.
   Spline becoming overconstraint, control point becomes red.
  The undo restore well Sline color but not the control
  points color
  

Problem conclusion

• THIS PROBLEM WILL BE FIXED ON
    CATIA VERSION 5 RELEASE 8 GA level.
  NOTE THAT THIS PROBLEM WILL ALSO BE FIXED ON V5R7SP04.
  
  Spline graphic properties were not managed during undo command.
  The problem is fixed. Original points color is restored after
  the undo command.
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Modules/Macros

•    FILE
  

Fix information

• Fixed component name

  CATIA V5 NT_INT

• Fixed component ID

  569151000

Applicable component levels

• R507 PSN

     UP