HD30211: PART DESIGN : DRAFT ANALYSIS DOES NOT WORK CORRECTLY

APAR status

• Closed as user error.

Error description

• Problem:
  In the case of the slope of 3 degrees, Draft
  Analysis does not work correctly. By the "Draft
  Analysis" command, when the angle of a draft is
  three degrees or less, analysis is not performed
  correctly.
  .
  Scenario
  1. Start CATIAV5.
  2. Open Part1.CATPart.
  3. Check "Draft Angle".
  Draft.1=2.5deg
  Draft.2=2.0deg
  Draft.3=1.5deg
  Draft.4=1.0deg
  4. Select "Draft Analysis" icon.
  5. Select "Part Body" and set "Draft Analysis"
  panel.
  >>>Analysis is not performed correctly. This is
  trouble.
  Usually, it analyzes in many cases to the slope face
  of three degrees or less.
  .
  .
  

Local fix

Problem summary

Problem conclusion

Temporary fix

Comments

• Incident Diagnosis
  Draft Analysis does not work correctly
  .
  Correct Application
  You must use inverse button in clicking it to see
  the correct analysis.
  .
  Documentation Reference
  FreeStyle
  Getting Started
  draft analysis
  .
  .
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels