HD26587: GENERATIVE DRAFTING / THREAD IS NOT DISPLAYED IN THE DRAWING FO R A HOLE ON UPDATING THE PART

APAR status

• Closed as program error.

Error description

• GENERATIVE DRAFTING / THREAD IS NOT
  DISPLAYED IN THE DRAWING FOR A HOLE ON
  UPDATING THE PART
  .
  

Local fix

Problem summary

• GENERATIVE DRAFTING / THREAD IS NOT DISPLAYED IN THE DRAWING FO
  R A HOLE ON UPDATING THE PART
  GENERATIVE DRAFTING / THREAD IS NOT
  DISPLAYED IN THE DRAWING FOR A HOLE ON
  UPDATING THE PART
  .
  

Problem conclusion

• THIS PROBLEM WILL BE FIXED ON CATIA VERSION
  5 RELEASE 15 GA level.
  .
  Incident Diagnosis
  GENERATIVE DRAFTING / THREAD IS NOT
  DISPLAYED IN THE DRAWING FOR A HOLE ON
  UPDATING THE PART
  .
  Correction Explanation
  The context given to ask the 3D for threads was
  not always the same. At creation it is the good one,
  but at update time it was a bad one which was
  computed. Then the generated thread seem to be
  bad so it was destroyed.
  Changes have been made so that the context is
  always the same : the good one.
  .
  Answer and By-Pass
  .
  With the command "c: force update" the threads
  will reappear (and next disappear and then re-
  appear again and again at each update)
  .
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5/NT/200

• Fixed component ID

  569151000

Applicable component levels

• R515 PSN

     UP