HD19560: PARTDESIGN / PAD CREATION FAILS BECAUSE OF INVALID PROFILE ALTH OUGH GSD EXTRUDE AND CLOSE SURFACE ARE OK WITH PROFILE

APAR status

• Closed as suggestion for future release.

Error description

• PARTDESIGN / PAD CREATION FAILS BECAUSE OF
  INVALID PROFILE ALTHOUGH GSD EXTRUDE AND
  CLOSE SURFACE ARE OK WITH PROFILE
  .
  Scenario:
  -----------
  1- Open sent CATPart in Part Design workbench.
  2- Create a pad using "Courbe" curve as profile.
  === Feature Definition Error message "The
  selected sketch isn't valid for the feature you want
  to create"
  .
  3. Enter GSD workbench
  4. Extrude the curve on XY direction
  5. In Part design, create Close Surface with the
  extrude
  === close surface can be created
  .
  Expectd result : pad can be created.
  .
  

Local fix

Problem summary

Problem conclusion

Temporary fix

Comments

• THIS APAR IS CONSIDERED AS A SUGGESTION
  FOR IMPROVEMENT WHICH CANNOT BE
  INCORPORATED IN VERSION V5R14
  PLEASE CONTACT YOUR SUPPORT DEPARTMENT IN
  ORDER TO OPEN A REQUIREMENT FORM.
  .
  Incident Diagnosis :
  The user is not able to create a Pad in Part design
  with given profile, although it is possible in GSD.
  .
  Justification for a development :
  This is due to actual limitation in Part design. An
  enhancement has to be done to allow PartDesign to
  heal the input and to give a warning to the user
  when the input is healed.
  .
  Answer and By-Pass
  For now error message has been modified to
  explain the nature of pad failure : from V5R12
  SP07, V5R13 SP03 and V5R14 GA, following
  feature definition error appears :
  " The selected sketch is self intersecting"
  .
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels