HD14030: SKETCHER / BY USING " CUT PART BY SKETCH PLANE " COMMAND IN BAC K VIEW , PART OF REMAINING 3D GEOMETRY IS NOT DISPLAYED

APAR status

• Closed as unreproducible in next release.

Error description

• scenario (model dependent)
  ---------
  1. Open the sent .CATProduct.
  2. Double click "Test1".
  3. Select "Sketch" icon.
  4. Select "yz plane".
  5. Select "Front View" icon.
  6. Select "Cut Part by Sketch Plane" icon.
  - OK This is normal behavior.
  7. Select "Cut Part by Sketch Plane" icon.
  8. Select "Back View" icon.
  9. Select "Cut Part by Sketch Plane" icon.
  === KO : The obtained geometry in 3D is not cut
  as expected.
  .
  Expected result :It should be the same output in
  step6.
  
  .
  

Local fix

Problem summary

• SKETCHER / BY USING " CUT PART BY SKETCH PLANE " COMMAND IN BAC
  K VIEW ,  PART OF REMAINING 3D GEOMETRY IS NOT DISPLAYED
  scenario (model dependent)
  ---------
  1. Open the sent .CATProduct.
  2. Double click "Test1".
  3. Select "Sketch" icon.
  4. Select "yz plane".
  5. Select "Front View" icon.
  6. Select "Cut Part by Sketch Plane" icon.
  - OK This is normal behavior.
  7. Select "Cut Part by Sketch Plane" icon.
  8. Select "Back View" icon.
  9. Select "Cut Part by Sketch Plane" icon.
  === KO : The obtained geometry in 3D is not cut
  as expected.
  .
  Expected result :It should be the same output in
  step6.
  
  .
  

Problem conclusion

Temporary fix

Comments

• THE PROBLEM WAS SUBMITTED ON :
  CATIA VERSION 5 RELEASE 11.
  THIS PROBLEM IS NOT REPRODUCIBLE ON :
  CATIA VERSION 5  RELEASE 13 GA level AND ON
  V5R12 SP04
  .
  It is not reproduced from V5R11 SP2.
  
  .
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5/NT/200

• Fixed component ID

  569151000

Applicable component levels

• R513 PSN

     UP