HD12375: PARTDESIGN / ASSEMBLE BOOLEAN OPERATION FAILS :" ONE BODY . DOES NOT CUT RIGHT ACROSS THE OTHER " MESSAGE OCCURS

APAR status

• Closed as program error.

Error description

• PARTDESIGN / ASSEMBLE BOOLEAN OPERATION
  FAILS :" ONE BODY DOES NOT CUT RIGHT
  ACROSS THE OTHER " MESSAGE OCCURS
  .
  Scenario  (model dependent)
  ----------
  1.Open the sent .CATPart
  2. Click MB3 on "Body.3"  and assemble it
  after "Body.2"
  ==  Error occurs : "One body does not cut right
  across the other one: the split cannot be
  computed."
  .
  Remarks :
  - This boolean operation works in V4
  - Under OpenBody.1, "Extract.1" and "Extract.2"
  surfaces  have been extracted from the bodies
  involved in the boolean operation : the GSD
  Intersection fails between tthese extracts with
  message  : " there is no solution for this
  operation "
  .
  Bypass:
  Perform the union operation in CATIA V4, before
   migration of the assembled solids into CATIA V5.
  
  .
  

Local fix

Problem summary

• PARTDESIGN / ASSEMBLE BOOLEAN OPERATION FAILS :" ONE BODY .
   DOES NOT CUT RIGHT ACROSS THE OTHER " MESSAGE OCCURS
  PARTDESIGN / ASSEMBLE BOOLEAN OPERATION
  FAILS :" ONE BODY DOES NOT CUT RIGHT
  ACROSS THE OTHER " MESSAGE OCCURS
  .
  Scenario  (model dependent)
  ----------
  1.Open the sent .CATPart
  2. Click MB3 on "Body.3"  and assemble it
  after "Body.2"
  ==  Error occurs : "One body does not cut right
  across the other one: the split cannot be
  computed."
  .
  Remarks :
  - This boolean operation works in V4
  - Under OpenBody.1, "Extract.1" and "Extract.2"
  surfaces  have been extracted from the bodies
  involved in the boolean operation : the GSD
  Intersection fails between tthese extracts with
  message  : " there is no solution for this
  operation "
  .
  Bypass:
  Perform the union operation in CATIA V4, before
   migration of the assembled solids into CATIA V5.
  
  .
  

Problem conclusion

• THIS PROBLEM WILL BE FIXED ON CATIA
  VERSION 5 RELEASE 13GA level.
  NOTE THAT THIS PROBLEM WILL ALSO BE FIXED ON V5R12SP04.
  .
  Correction Explanation
  Failure of a curve surface intersection in a difficult
  configuration has been detected.
  .
  Answer :
  The problem is corrected : assemble can be created.
  
  .
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5/NT/200

• Fixed component ID

  569151000

Applicable component levels

• R512 PSN SP51204

     UP03/12/18 I 1000

• R513 PSN

     UP