HD10619: GSD: SHAPE FILLET WITH HOLD CURVE DOES NOT WORK PROPERLY

APAR status

• Closed as suggestion for future release.

Error description

• SCENARIO:
  1. Open to read the provided part
  2. Select Shapefillet function
  3. Uncheck both "trim support" boxes
  4. Select Split.5
  5. Select Split.4
  6. Invert both direction arrows
  7. Select Split.6 as Hold Curve.
  8. Select Line.3 as Spine.
  8. Click on preview.
  ===> Error message appear :
  Fillet cannot be initialized : modify radius or
  supports.
  Each support must be continuous (tangency).
  Multi-ribbon fillets are not yet allowed."
  .
  We get an error message stating that the supports
  must be continuous in tangency. They are
  continuous in tangency, and the fillet should be
  generated without problem since this is very
  simple geometry.
  .
  The purple Sketch.2 feature represents the desired
  circulat section
  that we expect.
  .
  
  .
  

Local fix

Problem summary

Problem conclusion

Temporary fix

Comments

• THIS APAR IS CONSIDERED AS A SUGGESTION FOR IMPROVEMENT WHICH C
  ANNOT BE INCORPORATED IN VERSION 5 R13
  PLEASE CONTACT YOUR SUPPORT DEPARTMENT IN ORDER TO OPEN A REQUI
  REMENT FORM.
  .
  Incident Diagnosis :
  Shape Fillet with Hold Curve does not work
  properly.
  .
  Development Request Justification :
  The problem is in the quick initialization mode. It requires an
   important fix only for the case of failure in this first mode.
   The correction cannot be made in the present releases.
  .
  
  .
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels