HD05989: FREESTYLE / CURVE ON SURFACE / CATIA CREATES TWO IDENTICAL CURVES

APAR status

• Closed as unreproducible in next release.

Error description

• Abstract:
  FREESTYLE / CURVE ON SURFACE / CATIA CREATES TWO IDENTICAL
  CURVES
  
  Scenario:
  1.start CATIA V5 R10 SP01
  2.open a new CATPart with workbench FSS
  3.create a surface e.g. planar patch
  4.select the function "Curve on surface"
  5.change into "creation type: point by point", any "mode" is
  possible to use
  6.select the surface
  7.create the curve and try to define the end point with a
  double-
  click (as described in the online-documentation)
  8.finish the function with "ok"
  CATIA creates two absolutely identical curves with the same
  quality! This is the bug.
  

Local fix

Problem summary

•  INCIDENT DIAGNOSIS:
  FREESTYLE / CURVE ON SURFACE / CATIA CREATES
  TWO IDENTICAL CURVES
  

Problem conclusion

Temporary fix

Comments

• THE PROBLEM WAS SUBMITTED ON :
      CATIA VERSION 5 RELEASE 10
  .
  THIS PROBLEM IS NOT REPRODUCIBLE ON :
      CATIA VERSION 5 RELEASE 12 GA level
   It is also not reproducible on V5R11 SP2
  
   INCIDENT DIAGNOSIS:
  FREESTYLE / CURVE ON SURFACE / CATIA CREATES
  TWO IDENTICAL CURVES
  
   REASON:
  Problem was reproduced on customer level (V5R10 SP1 and
  V5R9 SP4).
  Problem is no more reproduced on V5R11 SP2 and V5R12GA.
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5/NT/200

• Fixed component ID

  569151000

Applicable component levels

• R510 PSN

     UP

• R511 PSN

     UP