HD05721: CREATE A PARALLEL CURVE CAN BE USED ONLY ONT TIME CORRECTLY, AN D FROM THE 2ND TIME ON TO USE THIS FUNCTION WILL BE NOT CORRECT

APAR status

• Closed as unreproducible in next release.

Error description

• Scenario:
  1/ open the file.CATPart in the GSD workbench
  
  2/ select the function to create a parallel curve
  
  3/ select any one of boundary as the CURVE
  
  4/ select the surface as the SUPPORT
  
  then OK.
  You can see 3 curves created.This is normal.
  
  7/ Repeat the 2-6 steps on the other boundary , but now you onl
  y get
  one curve, there is  no repeated instances
  
  
  
  .
  

Local fix

Problem summary

• create a parallel curve can be used only ont time correctly, an
  d from the 2nd time on to use this function will be not correct
  Scenario:
  1/ open the file.CATPart in the GSD workbench
  
  2/ select the function to create a parallel curve
  
  3/ select any one of boundary as the CURVE
  
  4/ select the surface as the SUPPORT
  
  5/ offset : 10
  
  6/ select the option : REPEAT OBJECT AFTER OK
  
  Then you are asked to input the repeated instances , just "2",
  then OK.
  You can see 3 curves created.This is normal.
  
  7/ Repeat the 2-6 steps on the other boundary , but now you onl
  y get
  one curve, there is  no repeated instances
  
  
  
  .
  

Problem conclusion

Temporary fix

Comments

• THE PROBLEM WAS SUBMITTED ON :
  CATIA VERSION 5 RELEASE 10.
  THIS PROBLEM IS NOT REPRODUCIBLE ON :
  CATIA VERSION 5 RELEASE 12 GA level
  
  .
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5/NT/200

• Fixed component ID

  569151000

Applicable component levels

• R510 PSN

     UP

• R511 PSN

     UP