HD03325: GSD - SHAPE FILLET IS NOT CREATED WITH 10MM RADIUS :' FILLET CANNOT BE INITIALIZED ' ERROR OCCURS

APAR status

• Closed as program error.

Error description

• *Model dependent*
  .
  SCENARIO :
  ---------
  1> Open "F51_new.CATPART".
  2> Click "Shape_Fillet" icon.
  3> Select Support1 "Extract.5".
     Select Support2 "Extract.6".
     Set value of the radius to 10mm.
     Select Extremities "Maximum".
  4> Click "OK" in "Fillet Definition" panel.
  ==> "Update Error" is displayed.
  "Fillet_1:
  Fillet cannot be initialized : modify radius or supports.
  Each support must be continuous (tangency).
  Multi-ribbon fillets are not yet allowed."
  .
  The "Shape_Fillet" is not created.
  .
  Remark: with 7mm radius, fillet is created.
  

Local fix

Problem summary

• GSD - SHAPE FILLET IS NOT CREATED WITH 10MM RADIUS :' FILLET CA
  NNOT BE INITIALIZED ' ERROR OCCURS
  GSD - SHAPE FILLET IS NOT CREATED WITH 10MM RADIUS :' FILLET CA
  NNOT BE INITIALIZED ' ERROR OCCURS
  
  
  .
  

Problem conclusion

• INCIDENT DIAGNOSIS:
  GSD - SHAPE FILLET IS NOT CREATED WITH 10MM RADIUS :' FILLET
  CANNOT BE INITIALIZED ' ERROR OCCURS
  .
  TECHNICAL EXPLANATION FOR THE CORRECTION:
  For this given radius, twist problem occurs at shape fillet
  creation.
  Before this PER correction, initialization of fillet was not
  possible on a twisted solution in case it was the only
  detected solution.
  Here only twist is detected, initialization computation
  is now possible with the correction.
  But there is still twist problem, which is expected with 10mm
  radius ; new error message appears about this twist problem.
  .
  ANSWER AND POSSIBLE BY-PASS:
  Problem is closed PER since error message has been modified.
  Concerning the twist problem, it cannot be avoided :
  decrease radius to enable the fillet creation.
  
  PROBLEM CONCLUSION:
  THIS PROBLEM WILL BE FIXED ON
  CATIA VERSION 5 RELEASE 12 GA level
  NOTE THIS PROBLEM WILL ALSO BE FIXED ON V5R11SP02
  
  .
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5/NT/200

• Fixed component ID

  569151000

Applicable component levels

• R510 PSN

     UP

• R511 PSN SP51102

     UP03/06/06 N 1000