HD01072: PARTDESIGN / CANNOT CREATE A PARTICUALR RIB WHEN MODIFY ONE SKETCH OFFSET CONSTRAINT /

APAR status

• Closed as program error.

Error description

• Abstract:
  PARTDESIGN / CANNOT CREATE A PARTICUALR RIB  WHEN MODIFY ONE
  SKETCH OFFSET CONSTRAINT /
  
  Scenario :
  File / Open CATPart
  Double click on sketch.2
  Modify the Offset.96 :
   From 0,2mm to 0,21mm
  Exit from sketcher
  -> Appear the following error message :
     Rib.1 Topological Operators: an internal error leads to a
  bad geometrical configuration.
  

Local fix

Problem summary

• ---------
  File / Open 239.CATPart
  Double click on sketch.2
  Modify the Offset.96 :
   From 0,2mm to 0,21mm
  Exit from sketcher
  -> Appear the following error message :
     Rib.1 Topological Operators: an internal error leads to a ba
  d
     geometrical configuration.
  

Problem conclusion

• THIS PROBLEM WILL BE FIXED ON CATIA VERSION 5 RELEASE 12GA leve
  l.
  NOTE THAT THIS PROBLEM WILL ALSO BE FIXED ON V5R11 SP3.
  .
  It is necessary to create the rib again to take benefit of the
  correction
  
  .
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5/NT/200

• Fixed component ID

  569151000

Applicable component levels

• R509 PSN

     UP

• R510 PSN

     UP

• R511 PSN

     UP