HC99638: SKETCHER / INCONSISTENT SKETCH WHEN PERFORMING A REPLACE IN CONTEXT OF A PRODUCT : TANGENCY CONSTRAINTS ARE INCONSISTEN

APAR status

• Closed as suggestion for future release.

Error description

• In Product, a part is replaced with 'Replace component'
  command ; a curve of this part is used as input of a
  projection in a sketch.
  .
  After replace, system cannot solved the modified sketch and
  tangency constraints become inconsistent. That is the
  problem.
  .
  Rmq : When entering sketch, deactivating a tangency
  constraint and when moving a circle to fit more the expected
  configuration, system can then be solved, and sketch can be
  updated. This should be done automatically by system.
  

Local fix

Problem summary

Problem conclusion

Temporary fix

Comments

• THIS APAR IS CONSIDERED AS A SUGGESTION FOR IMPROVEMENT FOR
  CATIA.
  PLEASE CONTACT YOUR SUPPORT DEPARTMENT IN ORDER TO OPEN A
  REQUIREMENT FORM.
   .
   INCIDENT DIAGNOSIS:
  Sketcher / inconsistent sketch when performing a replace
   in context of a product : tangency constraints are
  inconsistent.
   .
   JUSTIFICATION FOR DEVLOPMENT REQUEST:
  Problem comes from the large modification of a use edge
   which cannot be solved by Sketcher solver.
  .
   ANSWER AND POSSIBLE BY-PASS:
  The development name for this enhancement is
   "Move and Evaluate". It is not scheduled at this time.
  .
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels