HD84745: FTA : PMI`S NOT SHOWING CORRECTLY IN CATIA V5R18 AS IT WAS IN CATIA R16

APAR status

• Closed as program error.

Error description

• FTA : PMI`s not showing  correctly in CATIA V5R18
  as it was in CATIA R16.
  1.Load the CATPart
  2.Datum (A4) is not visible with following options.
  Tools/Options/MechanicalDesign/FT&A/Display/Unde
  r View Annotation
  3.Datum(A4) becomes visible with following options:
  Tools/Options/MechanicalDesign/FT&A/Display/Unde
  r Annotation Set note.
  .
  

Local fix

Problem summary

• FTA : PMI`s not showing  correctly in CATIA V5R18 as it was in
  CATIA R16
  FTA : PMI`s not showing  correctly in CATIA V5R18
  as it was in CATIA R16.
  1.Load the CATPart
  2.Datum (A4) is not visible with following options.
  Tools/Options/MechanicalDesign/FT&A/Display/Unde
  r View Annotation
  3.Datum(A4) becomes visible with following options:
  Tools/Options/MechanicalDesign/FT&A/Display/Unde
  r Annotation Set note.
  .
  

Problem conclusion

• THIS PROBLEM WILL BE FIXED ON CATIA VERSION
  5 RELEASE 20 GA LEVEL.
  NOTE THAT THIS PROBLEM WILL ALSO BE FIXED
  ON V5R19SP05
  There are annotations without FTA View in the
  document. Transfering them to a new/exisiting
  view will not fix the problem in case of UnderView
  alone is on. New visualization of the annotation has
  to be created. For this clean the document for FTA
  12 errors and then perform the scenario.
  .
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 SOLARI

• Fixed component ID

  569104000

Applicable component levels

• R519 PSN SP51905

     UP09/07/31 I 1000