HD81786: THE SECTION IS NOT DISPLAYED WHEN SWITCHING TO FTA

APAR status

• Closed as Permanent restriction.

Error description

• The section is not displayed when switching to FTA
  SCENARIO
  1. Start CATIA V5R19.
  2. Open the Product1.CATProduct then change the
  WorkBench to Assembly design.
  3. Create the Section.
  4. Change the WorkBench to product FTA
  RESULT
  The Section is not displayed and the part display
  returns to original
  EXPECTED RESULT
  Section should be displayed even if WorkBench is
  changed to FTA.
  .
  

Local fix

Problem summary

• The section is not displayed when switching to FTA
  The section is not displayed when switching to FTA
  SCENARIO
  1. Start CATIA V5R19.
  2. Open the Product1.CATProduct then change the
  WorkBench to Assembly design.
  3. Create the Section.
  4. Change the WorkBench to product FTA
  RESULT
  The Section is not displayed and the part display
  returns to original
  EXPECTED RESULT
  Section should be displayed even if WorkBench is
  changed to FTA.
  .
  

Problem conclusion

• THIS PROBLEM IS PERMANENT RESTRICTION IN
  CATIA
  INCIDENT DIAGNOSIS:
  .
  A section created in Assembly design is not visible
  when workbench is changed to FTA.
  .
  .
  RESTRICTION EXAPLANATION:
  .
  FTA workbench uses the same clipping as the
  section tool in assembly design.
  Currently CATIA can display ONLY 1 clipping.
  When user enters the FTA workbench, there is a
  conflict with the visual of clipping and FTA
  takes control of the visual of the clipping.
  Due to this reason it is not possible to modify
  existing behavior.
  .
  .
  BY-PASS:
  .
  Double click or Update the section.
  Right click on the Section.2 object in the tree and
  click : Section.2 object -> Update the section.
  .
  .
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels