HD80628: INTDRAFT / TRANSLATE OFFSET CURVE TAKES TOO MUCH TIME

APAR status

• Closed as program error.

Error description

• Translate Offset Curve takes too much time.
  .
  SCENARIO:
  .
  1. Open attached CATDrawing file in R18SP06 and
  R17SP06.
  2. Refer to attached ppt and select the curve shown
  in presentation.
  3. From transformations command box select
  Translate command. Make sure that duplicate
  mode is ON.
  4. Provide start and end position.
  5. Result: curve is translated and operation takes
  roughly 2.5 minutes in R18
  In R17 it takes approximately 4 seconds..
  .
  6. Additionally on R18 level the curve is distorted.
  .
  .
  EXPECTED RESULT;
  .
  The time required for completing operation should
  be same as R17SP06: approximately 4 seconds.
  .
  And the curve shape should not be distorted.
  .
  .
  

Local fix

Problem summary

• INTDRAFT / Translate Offset Curve takes too much time
  Translate Offset Curve takes too much time.
  .
  SCENARIO:
  .
  1. Open attached CATDrawing file in R18SP06 and
  R17SP06.
  2. Refer to attached ppt and select the curve shown
  in presentation.
  3. From transformations command box select
  Translate command. Make sure that duplicate
  mode is ON.
  4. Provide start and end position.
  5. Result: curve is translated and operation takes
  roughly 2.5 minutes in R18
  In R17 it takes approximately 4 seconds..
  .
  6. Additionally on R18 level the curve is distorted.
  .
  .
  EXPECTED RESULT;
  .
  The time required for completing operation should
  be same as R17SP06: approximately 4 seconds.
  .
  And the curve shape should not be distorted.
  .
  .
  

Problem conclusion

• THIS PROBLEM WILL BE FIXED ON CATIA VERSION
  5 RELEASE 20 GA LEVEL.
  NOTE THAT THIS PROBLEM WILL ALSO BE FIXED
  ON V5R19SP04 AND ON V5R18SP08
  .
  INCIDENT DIAGNOSIS:
  .
  The way the constraint scheme was discribed to the
  solver was changed. Due to this change it was
  more difficult to find a solution during translate.
  .
  .
  CORRECTION EXPLANATION:
  .
  The previous method of constrain has been now re-
  used. With the old method, the time required for
  solution is less and hence the curve is translated in
  short time.
  .
  The problem is now fixed after this change.
  .
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 WIN 64

• Fixed component ID

  569165000

Applicable component levels

• R518 PSN SP51808

     UP09/02/24 I 1000