HD80083: GSMD: WALL ON EDGE NOT POSSIBLE BECAUSE TWO EDGES GETS SELECTED AS A SINGLE EDGE.

APAR status

• Closed as program error.

Error description

• GSMD: Wall on Edge not possible because two
  edges gets selected as a single edge.
  .
  SCENARIO:
  1) Start CATIA.
  2) Open the CATPart
  Workbench-Generative Sheet Metal Design
  3) Click on the wall on edge command
  The wall On Edge Definition window appears.
  4) Select one of the edges located between the
  pink face and the green face of the part
  Two edges gets selected as a single edge
  5) Click on preview
  .
  PROBLEM:
  Update error message appears. Wall on edge
  cannot be created because two edges gets selected
  as single edge.
  .
  

Local fix

Problem summary

• GSMD: Wall on Edge not possible because two edges gets selected
  as a single edge.
  GSMD: Wall on Edge not possible because two
  edges gets selected as a single edge.
  .
  SCENARIO:
  1) Start CATIA.
  2) Open the CATPart
  Workbench-Generative Sheet Metal Design
  3) Click on the wall on edge command
  The wall On Edge Definition window appears.
  4) Select one of the edges located between the
  pink face and the green face of the part
  Two edges gets selected as a single edge
  5) Click on preview
  .
  PROBLEM:
  Update error message appears. Wall on edge
  cannot be created because two edges gets selected
  as single edge.
  .
  

Problem conclusion

• THIS PROBLEM WILL BE FIXED ON CATIA VERSION
  5 RELEASE 20 GA LEVEL.
  NOTE THAT THIS PROBLEM WILL ALSO BE FIXED
  ON V5R19SP03
  Incident Diagnosis: While performing Wall on Edge,
  if limits were selected as UpToPlane/Surface,
  multiple edges get selected.
  .
  Correction Explanation:
  This problem was occuring on reported level
  because edge selction behavior was not ok if limits
  were selected as UpToPlane/Surface, while creating
  wall on edge.
  The correction has been done so that multiple
  edges will not get selected.
  .
  Bypass:Create the plane from the face of input
  body and use that as a limit body while creating
  wall on edge.
  .
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 NT>XP

• Fixed component ID

  569151000

Applicable component levels

• R518 PSN

     UP