HD76677: PHANTOM LINES IN SECTION VIEW ARE DISPLAYED AS SOLID LINES

APAR status

• Closed as suggestion for future release.

Error description

• Phantom lines in section view are displayed as solid
  lines
  .
  SCENARIO:
  .
  1. Open CATIA V5
  2. Open the CATProduct and the CATDrawing.
  3. Create a new View Select the Front view.
  Command and generate a front view .
  4. Create an aligned sectional view .
  5. RMB and In the Contextual menu For the Section
  view  and Select Overload properties.
  6. In the Characteristic window, Edit the Line
  thickness and change it to type 5 (1.4mm)
  thickness.
  7. Click Ok.
  8. Select the Hatching and Go to the Properties and
  change the type to ?None?.
  9. Go to the Specification tree and Select the
  Section view.
  .
  RESULTS OBTAINED:
  .
  Observe that abnormal behavior is seen, a line is
  seen in middle of the Dashed line of the boundary
  of the Section view.
  .
  EXPECTED RESULTS.
  .
  The Boundary lines should be seen correctly.
  .
  ADDITIONAL INFORMATION:
  .
   f Save as is Done as ?.pdf? then we can see that
  the Boundary is not seen correctly. Incorrect result
  is seen same as what is seen in the CATDrawing
  when the Section view is selected in the
  Specification tree.
  .
  .
  

Local fix

Problem summary

Problem conclusion

Temporary fix

Comments

• THIS APAR IS CONSIDERED AS A SUGGESTION
  FOR IMPROVEMENT FOR CATIA.
  PLEASE CONTACT YOUR SUPPORT DEPARTMENT IN
  ORDER TO OPEN A REQUIREMENT FORM.
  DEVELOPMENT REQUEST JUSTIFICATION:
  .
  The current behaviour is intended.
  In our understanding what is needed is the new
  capability to request in a view that no hatching
  should be generated at all, This is the enhancement
  request already identified by DS
  Currently no target release has been set for its
  availability.
  .
  BY PASS:
  .
  In order to remove the hatched zone from a
  section view, the area can be put either put in
  noshow or deleted. Please note that this will not be
  persistent if the view is updated, and the area will
  become visible again.
  .
  .
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels