HD72707: DRAFTING(GENDRAFT)/ DRAWING ADVANCED BOM : MASS PARAMETER IS NO T UPDATED

APAR status

• Closed as program error.

Error description

• DRAFTING(GENDRAFT)/ DRAWING ADVANCED
  BOM : MASS PARAMETER IS NOT UPDATED.
  SCENARIO:
  1. Start CATIA V5R18SP03.
  2. Open 'Product.CATProduct'
  Material associated with the part is Iron and
  mass of the part is 7.87Kg(Measured using
  command Measure inertia).
  3. Open 'Product.CATDrawing'
  Advandced BOM in the drawing displays the
  correct material and the correct mass
  of the Part.
  4. Switch to the Product Window.
  5. Replace Iron with Aluminium using apply
  material.
  Material associated with the part is Aluminium
  and weight of the part is 2.71Kg.
  6. Switch to the drawing window.
  7. Update the drawing.
  .
  RESULTS OBTAINED:
  In the advanced BOM, material is updated to
  Aluminium but mass is not updated to the new
  value.
  .
  EXPECTED RESULTS:
  Both material and mass should be updated to
  Aluminium and 2.71Kg respectively.
  .
  

Local fix

Problem summary

• DRAFTING(GENDRAFT)/ DRAWING ADVANCED BOM : MASS PARAMETER IS NO
  T UPDATED
  DRAFTING(GENDRAFT)/ DRAWING ADVANCED
  BOM : MASS PARAMETER IS NOT UPDATED.
  SCENARIO:
  1. Start CATIA V5R18SP03.
  2. Open 'Product.CATProduct'
  Material associated with the part is Iron and
  mass of the part is 7.87Kg(Measured using
  command Measure inertia).
  3. Open 'Product.CATDrawing'
  Advandced BOM in the drawing displays the
  correct material and the correct mass
  of the Part.
  4. Switch to the Product Window.
  5. Replace Iron with Aluminium using apply
  material.
  Material associated with the part is Aluminium
  and weight of the part is 2.71Kg.
  6. Switch to the drawing window.
  7. Update the drawing.
  .
  RESULTS OBTAINED:
  In the advanced BOM, material is updated to
  Aluminium but mass is not updated to the new
  value.
  .
  EXPECTED RESULTS:
  Both material and mass should be updated to
  Aluminium and 2.71Kg respectively.
  .
  

Problem conclusion

• THIS PROBLEM WILL BE FIXED ON CATIA VERSION
  5 RELEASE 19 GA LEVEL.
  .
  Incident Diagnosis:
  Mass parameter was not updated after design
  modification.
  .
  Correction Explanation:
  Correction has been done And now the mass is
  correctly updated with changa in material.
  .
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 NT>XP

• Fixed component ID

  569151000

Applicable component levels

• R519 PSN

     UP