HD69845: DRAFTING (INTDRAFT) / CREATION OF TRI-TANGENT CIRCLE IS NOT

APAR status

• Closed as program error.

Error description

• Drafting (IntDraft) / Creation of Tri-Tangent circle
  is not possible in case of two lines & a point.
  .
  Scenario:
  1. Open CATIA.
  2. Open CATDrawing.
  3. Create Tri-tangent Circel by using two lines & a
  point.
  .
  Problem: It does not create circle with a message.
  .
  Expected result: It should be created.
  .
  .
  

Local fix

Problem summary

• Drafting (IntDraft) / Creation of Tri-Tangent circle is not
  possible in case of two lines a point.
  Drafting (IntDraft) / Creation of Tri-Tangent circle
  is not possible in case of two lines & a point.
  .
  Scenario:
  1. Open CATIA.
  2. Open CATDrawing.
  3. Create Tri-tangent Circel by using two lines & a
  point.
  .
  Problem: It does not create circle with a message.
  .
  Expected result: It should be created.
  .
  .
  

Problem conclusion

• THIS PROBLEM WILL BE FIXED ON CATIA VERSION
  5 RELEASE 19 GA LEVEL.
  NOTE THAT THIS PROBLEM WILL ALSO BE FIXED
  ON V5R18SP05.
  INCIDENT DIAGNOSIS
  .
  Drafting (IntDraft) / Creation of Tri-Tangent circle
  is not possible in case of two lines & a point.
  .
  CORRECTION EXPLANATION
  .
  This was problem due to the change in the
  command to support some more elements, which
  has now been corrected.
  .
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 NT>XP

• Fixed component ID

  569151000

Applicable component levels

• R517 PSN

     UP

• R518 PSN SP51805

     UP08/06/02 I 1000