HD68473: DRAFTING (GENDRAFT) / THREAD DIMENSION IS NOT DISPLAYED CORRECT LY FOR A STANDARD THREADED HOLE DEFINED AS UDF.

APAR status

• Closed as unreproducible in next release.

Error description

• Drafting (GenDraft) / Thread dimension is not
  displayed correctly for a Standard Threaded Hole
  defined as UDF.
  .
  SCENARIO:
  .
  1. Open the CATPart and the CATDrawing.
  2. There are 3 yellow holes in the part.
  The issue is the thread dimension in Drafting of
  those 3 yellow holes.
  3. In the Drafting, two Thread Dimensions have
  been applied to two of the threads on the front
  view. In case of the thread coming from one of
  the yellow holes, only a non-standard thread
  dimension is displayed (here a diameter of 16mm).
  This thread dimension has been created with
  the Thread Dimension command in Drafting.
  3. The correct display of the thread dimensions
  value should be "M16"
  4. When using Thread/Tap Analysis command in
  Part Design workbench, the thread is displayed
  properly.
  5. Why do we not get the standard dimension in
  Drafting?
  .
  EXPECTED RESULT:
  .
  Thread dimensions should be displayed correctly.
  .
  

Local fix

Problem summary

• Drafting (GenDraft) / Thread dimension is not displayed correct
  ly for a Standard Threaded Hole defined as UDF.
  Drafting (GenDraft) / Thread dimension is not
  displayed correctly for a Standard Threaded Hole
  defined as UDF.
  .
  SCENARIO:
  .
  1. Open the CATPart and the CATDrawing.
  2. There are 3 yellow holes in the part.
  The issue is the thread dimension in Drafting of
  those 3 yellow holes.
  3. In the Drafting, two Thread Dimensions have
  been applied to two of the threads on the front
  view. In case of the thread coming from one of
  the yellow holes, only a non-standard thread
  dimension is displayed (here a diameter of 16mm).
  This thread dimension has been created with
  the Thread Dimension command in Drafting.
  3. The correct display of the thread dimensions
  value should be "M16"
  4. When using Thread/Tap Analysis command in
  Part Design workbench, the thread is displayed
  properly.
  5. Why do we not get the standard dimension in
  Drafting?
  .
  EXPECTED RESULT:
  .
  Thread dimensions should be displayed correctly.
  .
  

Problem conclusion

Temporary fix

Comments

• THE PROBLEM WAS SUBMITTED ON :
  CATIA VERSION 5 RELEASE 16.
  THIS PROBLEM IS NOT REPRODUCIBLE ON :
  CATIA VERSION 5 RELEASE 19 GA level.
  .
  INCIDENT DIAGNOSIS:
  .
  Drafting (GenDraft) / Thread dimension is not
  displayed correctly for a Standard Threaded Hole
  defined as UDF.
  .
  ADDITIONAL INFORMATION:
  .
  This problem is reproducible on R16 SP05 level.
  .
  This problem is not reproducible on R19 GA level if
  the dimensions are recreated on this level.
  .
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 NT>XP

• Fixed component ID

  569151000

Applicable component levels

• R519 PSN

     UP