HD61497: INTEROP LCA V5 - BAD PERFORMANCE WITH CREATING APPROXIMATE VIEW

APAR status

• Closed as Permanent restriction.

Error description

• INTEROP LCA V5 - Bad performance with creating
  Approximate View. Performance of loading Data
  into CATIA V5 is 3 times poorer with ENOVIA LCA,
  compared to File based.
  Scenario:
  1. Tools - Options: Activate "Work with the Cache-
  System"
  2. Send an Assembly to CV5 as Assembly
  3. Create a new Drawing
  4. Tools - Options: View Mode: Approximate Mode
  5. Create the Front View
  ==> before calculating the Geometry, all
  Documents are loaded automatically
  .
  Switch the Assembly to Desing Mode.
  Save the Assembly and all its Parts to local Disk
  with Save
  Management.
  Close LCA
  Restart CATIA (restart the computer if you like)
  1. Tools - Options: Activate "Work with the Cache-
  System"
  2. Open the CATProduct from Local disk
  3. Create a new Drawing
  4. Tools - Options: View Mode: Approximate Mode
  5. Create the Front View
  ==> the Geometry is calculated immediately; no
  automatic
  loading of Documents
  .
  By the way: Analyzing this Problem we observed,
  that the Performance of loading Data into CATIA is
  3 times poorer with LCA, compared to File based.
  .
  

Local fix

Problem summary

• INTEROP LCA V5 - Bad performance with creating Approximate View
  INTEROP LCA V5 - Bad performance with creating
  Approximate View. Performance of loading Data
  into CATIA V5 is 3 times poorer with ENOVIA LCA,
  compared to File based.
  Scenario:
  1. Tools - Options: Activate "Work with the Cache-
  System"
  2. Send an Assembly to CV5 as Assembly
  3. Create a new Drawing
  4. Tools - Options: View Mode: Approximate Mode
  5. Create the Front View
  ==> before calculating the Geometry, all
  Documents are loaded automatically
  .
  Switch the Assembly to Desing Mode.
  Save the Assembly and all its Parts to local Disk
  with Save
  Management.
  Close LCA
  Restart CATIA (restart the computer if you like)
  1. Tools - Options: Activate "Work with the Cache-
  System"
  2. Open the CATProduct from Local disk
  3. Create a new Drawing
  4. Tools - Options: View Mode: Approximate Mode
  5. Create the Front View
  ==> the Geometry is calculated immediately; no
  automatic
  loading of Documents
  .
  By the way: Analyzing this Problem we observed,
  that the Performance of loading Data into CATIA is
  3 times poorer with LCA, compared to File based.
  .
  

Problem conclusion

• THIS PROBLEM IS PERMANENT RESTRICTION IN
  CATIA
  Incident Diagnosis
  INTEROP LCA V5 - Bad performance with creating
  Approximate View
  Restriction Explanation
  In case of ENOVIA LCA (or ENOVIA VPM)
  environment, CATIA needs to load some additional
  CATPart data compared to file-based environment,
  for specific treatment.
  From V5R15 level, in case of file-based drawing in
  approximate/CGR/Raster mode, only the .cgr data
  are loaded, whereas in case of ENOVIA, we also
  load a specific proxy container from Part
  document : this is the reason why performance are
  lower compared with file.
  By-Pass
  There is no by-pass.
  .
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels