HE07072: THE EDGE FILLET WITH BLEND CORNER CANNOT BE CREATED

APAR status

• Closed as program error.

Error description

• Scenario:
  1. Launch CATIA.
  2. Create a part with a corner and three adjacent edges.
  3. GSD/Part Design WB.
  4. Edge Fillet > More
  5. Radius = 5mm
  6. Setback distance = 5mm
  7. Blend corner(s) > MB3 > Create by edges
  8. Click ?Preview? button
  Result:
  In V5R20GA level, Fillet creation is previewed properly.
  In higher levels, CATIA throws an internal error message.
  Expected Result:
  The ?Preview? button should display proper ?Edge Fillet with
  the Blend corner?, like the behavior in V5R20GA level.
  

Local fix

• empty
  

Problem summary

• Scenario:
  1. Launch CATIA.
  2. Create a part with a corner and three adjacent edges.
  3. GSD/Part Design WB.
  4. Edge Fillet > More
  5. Radius = 5mm
  6. Setback distance = 5mm
  7. Blend corner(s) > MB3 > Create by edges
  8. Click ?Preview? button
  Result:
  In V5R20GA level, Fillet creation is previewed properly.
  In higher levels, CATIA throws an internal error message.
  Expected Result:
  The ?Preview? button should display proper ?Edge Fillet with
  the Blend corner?, like the behavior in V5R20GA level.
  

Problem conclusion

• NOTE THAT THIS PROBLEM WILL ALSO BE FIXED ON V5R21 SP1.
  Additional Closure Information:
  INCIDENT DIAGNOSIS:
  The Edge Fillet with same "Radius and Setback Distance" and
  enabled "Blend Corner" cannot be Previewed.
  CLOSURE DESCRIPTION:
  Error in creation occurred due to change in algorithm.
  Backed up with previous algorithm. No more problem in Fillet
  Creation and Preview.
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 NT>XP

• Fixed component ID

  569151000

Applicable component levels

• R521 PSN SP52101

     UP11/07/18 I 1000