HE05491: FILL SURFACE IS CREATED, BUT A CURVE IS NOT ON THE SURFACE.

APAR status

• Closed as program error.

Error description

• Scenario:
  1. Build the attached sample workspace
  2. Launch the CATIA
  3. Open the attached part document
  4. Run the ???TestAddinC??? command in ???Samplelb??? toolbar
  It created a surface (Fill) using
  CATGSMCreateTopologicalAutomaticFill method
  Actual Result:
  Curve.2 used for fill does not seem to be on created surface
  Expected Result:
  Curve.2 is a bad shape. So it is preferred to have error
  message.
  

Local fix

• empty
  

Problem summary

• Scenario:
  1. Build the attached sample workspace
  2. Launch the CATIA
  3. Open the attached part document
  4. Run the ?TestAddinC? command in ?Samplelb? toolbar
  It created a surface (Fill) using
  CATGSMCreateTopologicalAutomaticFill method
  Actual Result:
  Curve.2 used for fill does not seem to be on created surface
  Expected Result:
  Curve.2 is a bad shape. So it is preferred to have error
  message.
  

Problem conclusion

• NOTE THAT THIS PROBLEM WILL ALSO BE FIXED ON V5R21 SP1.
  Additional Closure Information:
  Technical explanation of the defect:
  A Multi Domain wire has to be taken into account.
  After that an error message concerning the joining of input
  curves will be returned because there is an invalid input
  curve
  Technical explanation of the correction:
  Multi domain wires are detected so that in this case the join
  of curves to Fill is impossible
  An error message is returned.
  Possible by-pass and/or correction limitation:
  NONE
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 NT>XP

• Fixed component ID

  569151000

Applicable component levels

• R521 PSN SP52101

     UP11/07/18 I 1000