HE05152: GSMD : USER PATTERN : UNABLE TO CREATE USER PATTERN OF CUTOUT FE ATURE IN A SPECIFIC CATPART.

APAR status

• Closed as duplicate of another APAR.

Error description

• SCENARIO:
  In a specific CATPart, it is not possible to create User
  Pattern of Cutout feature.
  Update error appear as
  "User pattern
  An error occurred during the build of folded pattern.
  Check that each instance of the pattern completely lies on a
  single and planar support." -This is the problem.
  EXPECTED RESULT:
  User Pattern should be possible.
  

Local fix

• empty
  

Problem summary

• SCENARIO:
  In a specific CATPart, it is not possible to create User
  Pattern of Cutout feature.
  Update error appear as
  "User pattern
  An error occurred during the build of folded pattern.
  Check that each instance of the pattern completely lies on a
  single and planar support." -This is the problem.
  EXPECTED RESULT:
  User Pattern should be possible.
  

Problem conclusion

• THE PROBLEM HAS BEEN FOUND TO BE ANOTHER SYMPTOM OF THE
  PROBLEM REPORTED IN  APAR HD81737 OR THE ANSWER MADE FOR THIS
  DUPLICATE APAR APPLIES ALSO TO THE CURRENT PROBLEM.
  Additional Closure Information:
  .
  INCIDENT DIAGNOSIS:
  The support of the pattern (which is wall) is not the same as
  the support of the item to pattern (which is cutout as Cutout
  lies on the stamp). Both supports are not in the same plane.
  After pattern, the instances of the pattern (i.e. cutout
  instances ) are expected to lie on the wall. however as both
  supports are not in the same plane, pattern of cutout is not
  possible and error message appear. In the BR CATPart, the
  preview shows that the instances of pattern are not correctly
  shown on plane of Wall.
  .
  CORRECTION EXPLANATION:
  Since R20GA level, the behavior of pattern of Cutouts is
  changed by BR10000066878 and now it gives more stable
  results. Now the new algorithm enables the pattern only if
  the instances are on the same plane as the item to pattern
  (Cutout)
  User will have to follow below steps to get user pattern of
  cutout on wall surface.
  Methodology:
  1. Create Cutout feature on wall
  2. Create Pattern of cutout feature
  3. Then Create Stamp feature
  

Temporary fix

Comments

• This APAR is a duplicate of HD81737
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 NT>XP

• Fixed component ID

  569151000

Applicable component levels