HE05034: DRAFTING:CREATE LINE USING ORIGIN POINT, END POINT IS NOT CREATE D

APAR status

• Closed as Permanent restriction.

Error description

• SCENARIO:
  1. File / New / Drawing
  2. Click New View icon
  Indicate position
  3. Click Line icon
  Select origin point of the View
  4. Indicate place and line is created
  =End point is not created at origin point
  Additional info:
  If creating line using Snap to Point function, end point is
  created.
  .
  PROBLEM:
  End point is not created at origin point .
  .
  EXPECTED RESULT:
  End point should be created even if creating line using
  origin point.
  There is no end point, impossible to move line
  This behavior is same as Sketcher.
  If this is CATIA specification, please let us know the
  description in documentation.
  

Local fix

• empty
  

Problem summary

• SCENARIO:
  1. File / New / Drawing
  2. Click New View icon
  Indicate position
  3. Click Line icon
  Select origin point of the View
  4. Indicate place and line is created
  =End point is not created at origin point
  Additional info:
  If creating line using Snap to Point function, end point is
  created.
  .
  PROBLEM:
  End point is not created at origin point .
  .
  EXPECTED RESULT:
  End point should be created even if creating line using
  origin point.
  There is no end point, impossible to move line
  This behavior is same as Sketcher.
  If this is CATIA specification, please let us know the
  description in documentation.
  

Problem conclusion

• THIS PROBLEM IS PERMANENT RESTRICTION IN CATIA.
  Additional Closure Information:
  Incident Diagnosis:
  Create line using origin point, end point is not created.
  .
  Restriction Explanation:
  When creating a line or any curve in Drafting/Sketcher, when
  selecting the origin as an
  end point, the origin is shared between view/sketch axis
  system and the created curve. No
  new end point is created.
  Smart pick re-uses as much as possible existing points during
  geometry creation. This is a
  specification for smart pick.
  .
  An end point is created if "snap option" is selected because
  the coincidence with the origin
  is not detected (no coincidence icon is shown).
  .
  By-Pass:
  It is possible to separate the created curve from the origin
  by selecting the origin and launching
  "break" command.
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels