HD99435: THE INERTIA DATA CANNOT BE COMPUTED ON A PARTICULAR SOLID BODY

APAR status

• Closed as Permanent restriction.

Error description

• Scenario:
  1)Open specific CATpart containing certain Boolean operations.
  2)Go measure inertia command.
  3)select a partbody under specific Boolean operations.
  Problem:
  CATIA shows error "selection not valid".
  Expected result:
  CATIA should not throw error.Inertia should be calculated.
  

Local fix

• empty
  

Problem summary

• Scenario:
  1)Open specific CATpart containing certain Boolean operations.
  2)Go measure inertia command.
  3)select a partbody under specific Boolean operations.
  Problem:
  CATIA shows error "selection not valid".
  Expected result:
  CATIA should not throw error.Inertia should be calculated.
  

Problem conclusion

• THIS PROBLEM IS PERMANENT RESTRICTION IN CATIA
  Additional Closure Information:
  Incident Diagnosis:
  Cannot compute mass properties
  Reason:
  It seems that the different PCurves used to
  delimit face 5587 are defined outside the U, V
  limits of the underlying sphere surface. This is
  not an authorized configuration and explains the
  error. Note that any other operator requiring the
  face???s 2D bounding box will also trigger the same
  error.
  By-Pass:
  None
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels