HD90546: THE PROJECTION RESULT OF A CURVE ON A PLANE IS POINT WHEN THE NE SOLUTION OPTION IS ACTIVATED.

APAR status

• Closed as program error.

Error description

• SCENARIO:
  1.Create a 3D Surface.
  2.Extract the boundary of this surface to create a 3D Curve
  3.Create a Plane -  Normal to this curve  at an end point.
  4.Create Projection with these two inputs- 3D Curve as Projected
  Plane as Support
  Activate the Nearest Solution option for the Projection command
  click OK
  .
  OBSERVATION:
  The result of projection command is a point instead of a curve.
  This is the problem.
  

Local fix

Problem summary

• SCENARIO:
  1.Create a 3D Surface.
  2.Extract the boundary of this surface to create a 3D Curve
  3.Create a Plane - ???Normal to this curve??? at an end point.
  4.Create Projection with these two inputs- 3D Curve as
  Projected and Plane as Support
  Activate the Nearest Solution option for the Projection
  command and click OK
  .
  OBSERVATION:
  The result of projection command is a point instead of a
  curve.
   This is the problem.
  

Problem conclusion

• THIS PROBLEM WILL BE FIXED ON CATIA  VERSION V5R21 GA level.
  NOTE THAT THIS PROBLEM WILL ALSO BE FIXED ON V5R20 SP1.
  Additional Closure Information:
  Incident Diagnosis:
  The projection result of a curve on a plane is point when the
  nearest solution option is activated.
  .
  Correction Explanation:
  The previous result obtained was because of instability in
  the operation.
  The projection of curve on the plane is a curve now.
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 NT>XP

• Fixed component ID

  569151000

Applicable component levels

• R519 PSN

     UP