HD89431: FTA - CHECK VALIDITY IN GEOMETRY CONNECTION MANAGEMENT NOT POSS IBLE

APAR status

• Closed as unreproducible in next release.

Error description

• FTA / Geometry Connection Management / Check Validity : it is
  not possible with this CATPart to check validity after adding
  a geometry to the tolerance
  Scenario:
  1. Open CATIA V5 after activating specific variable
  2. Select FTA object "position surfacic profile.3"
  3. Contextual menu / "Associated Geometry" - "Geometry
     Connection Management"
  4. "Connect" any face to the tolerance
  5. Select "Check validity"
  
  Result :
  ERROR: the dialog is closed without performing any result.
  
  Expected Result:
  It should show OK status.
  The face should be checked due to
  tolerancing standard and added to the tolerance. Finally the
  tolerance should be white (resolved) again
  

Local fix

Problem summary

• FTA / Geometry Connection Management / Check Validity : it is
  not possible with this CATPart to check validity after adding
  a geometry to the tolerance
  Scenario:
  1. Open CATIA V5 after activating specific
  variable
  2. Select FTA object "position surfacic profile.3"
  3. Contextual menu / "Associated Geometry" - "Geometry
  Connection Management"
  4. "Connect" any face to the tolerance
  5. Select "Check validity"
  Result :
  ERROR: the dialog is
  closed without performing any result.
  Expected Result:
  it
  should show OK status.
  The face should be checked due to
  tolerancing standard and added to the tolerance. Finally the
  tolerance should be white (resolved) again
  

Problem conclusion

Temporary fix

Comments

• THE PROBLEM WAS SUBMITTED ON CATIA VERSION V5R19.
  THIS PROBLEM
  IS NOT REPRODUCIBLE ON CATIA VERSION V5R20 GA level and
  VERSION V5R19 SP6.
  Additional Closure Information:
  Incident
  Diagnosis:
  Check validity in geometry connection management is
  not possible
  Technical Reason:
  This problem is caused by a
  variable available on V5R19SP3 only.
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 WIN 64

• Fixed component ID

  569165000

Applicable component levels

• R519 PSN SP51906

     UP09/10/27 I 1000