HD88520: GSD: VARIABLE RADIUS FILLET: EDGES TO KEEP : ERROR MESSAGE IS N OT DISPLAYED WHILE CREATING VARIABLE RADIUS FILLET WITH EDGES T

APAR status

• Closed as unreproducible in next release.

Error description

• SCENARIO:
  1. Start CATIA V5 with HD2 license
  2. Open the
  attached CATPart
  Workbench: Generative shape Design
  3.
  Deactivate earlier created Variable Edge Fillet.6
  4. Select
  Variable radius fillet command
  5. Select the top edges to
  fillet
  6. Select bottom edge as Edges to keep-This is
  important point.
  7. Change two radius values from 8 mm to
  6mm
  8. Select Ok
  Observation: Variable radius fillet is
  created with different radius values at two locations.
  As per
  documentation Part design / Creating Variable Radius Fillets /
  Edge(s) to Keep Option, It is not possible to create the
  variable fillet with edges to keep option without CFO sharable
  license
  However without CFO sharable license, Variable radius
  fillet is created with different radius values at two
  location. This is wrong behavior.
  PROBLEM:
  Error message is
  not displayed while creating variable radius fillet with edges
  to keep option and non-uniform radius values when CFO sharable
  license is not selected.
  

Local fix

Problem summary

• SCENARIO:
  1. Start CATIA V5 with HD2 license
  2. Open the
  attached CATPart
  Workbench: Generative shape Design
  3.
  Deactivate earlier created Variable Edge Fillet.6
  4. Select
  Variable radius fillet command
  5. Select the top edges to
  fillet
  6. Select bottom edge as Edges to keep-This is
  important point.
  7. Change two radius values from 8 mm to
  6mm
  8. Select Ok
  Observation: Variable radius fillet is
  created with different radius values at two locations.
  As per
  documentation Part design / Creating Variable Radius Fillets /
  Edge(s) to Keep Option, It is not possible to create the
  variable fillet with edges to keep option without CFO sharable
  license
  However without CFO sharable license, Variable radius
  fillet is created with different radius values at two
  location. This is wrong behavior.
  PROBLEM:
  Error message is
  not displayed while creating variable radius fillet with edges
  to keep option and non-uniform radius values when CFO sharable
  license is not selected.
  

Problem conclusion

Temporary fix

Comments

• THE PROBLEM WAS SUBMITTED ON :
  VERSION V5R18.
  THIS
  PROBLEM IS NOT REPRODUCIBLE ON :
  VERSION V5R20 GA
  level
  Additional Closure Information:
  Reason: The correct
  message is displayed on this level.
  The message says, "The
  license configuration does not allow creation of variable
  fillet with keep edges."
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 NT>XP

• Fixed component ID

  569151000

Applicable component levels

• R520 PSN

     UP