HD87983: CATIA NOT RESPONDING WHEN OPENING A SPECIFIC R19 PART AFTER CHA NGING THE 3D ACCURACY VALUE TO 0.01.

APAR status

• Closed as unreproducible in next release.

Error description

• SCENARIO:
  Start CATIA V5 with Default CATSettings
  1. Open the attached PART then close the part
  2. Change the 3D Accuracy
  go to Tools/Options/GENERAL/Display/Performance
  set the 3D accuracy to FIXED= 0.01
  (keep curves accuracy ratio = 1.00x3D accuracy)
  3. Open again the attached part.
  .
  OBSERVATION:
  CATIA is not responding
  .
  

Local fix

Problem summary

• SCENARIO:
  Start CATIA V5 with Default CATSettings
  1. Open the
  attached PART then close the part
  2. Change the 3D Accuracy
  go to Tools/Options/GENERAL/Display/Performance
  set the 3D
  accuracy to FIXED= 0.01
  (keep curves accuracy ratio = 1.00x3D
  accuracy)
  3. Open again the attached
  part.
  .
  OBSERVATION:
  CATIA is not responding
  

Problem conclusion

Temporary fix

Comments

• THE PROBLEM WAS SUBMITTED ON :
  VERSION V5R19.
  THIS
  PROBLEM IS NOT REPRODUCIBLE ON :
  VERSION V5R20 GA level
  VERSION V5R19 SP6.
  Additional Closure Information:
  .
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 WIN 64

• Fixed component ID

  569165000

Applicable component levels

• R519 PSN SP51906

     UP09/10/27 I 1000