II14358: MAY SEE CF CHANGES ON AN ACTIVATE THAT DOES NOT SEEM TO INVOLVE CF CHNGS SINCE IOS SAVES LAST CCB WHEN SYSTEM GOES OUT OF SYNC

APAR status

• Closed as canceled.

Error description

• May seem CF Devices changed even when the IODF SOURCE and
  Target do not change anything regarding these CF's.
  Msg's would show something like this;
  IOS500I ACTIVATE RESULTS 030
  TEST DETECTED CONDITIONS WHICH WOULD RESULT IN ACTIVATE FAILURE
  REASON=0381,CANNOT DELETE COUPLING FACILITY CU
  FFE1...................
  DESCTEXT=COUPLING FACILITY IS STILL
  ACTIVE.........................
  COMPID=SCIXL
  NOTE = 0100,SOFTWARE-ONLY CHANGE
  COMPID=SC1C3
  NOTE = 0108,H/W AND S/W CONFIGURATION DEFINITIONS WILL BE BACK
  in SYNC.
  .
  The reason for this is that
  IOSVCMIN which calls the XCF routing.
  This routine will save the CCB IF it causes the
  software and hardware configuration to get out of sync.
  When the software and hardware configuration get back in sync
  XCF is then notified with the saved CCB's.
  .
  CMVC item has been opened to IOS to add a ctrace entry for
  the saved CCB.
  ****************************************************************
  NOTE:  If you are receiving this message and this APAR does not
  describe the situation, ie.
  This is an Activate Test or Activate w/out SOFT then most likely
  a CF definition (CHPID, Control Unit or Device)
  in the TARGET IODF has changed.
   This may occur if the CF was disconnected and reconnected or if
  the CHPIDs to the CF were removed and added back in a
  different order by the user during an HCD session.
  
  
  Run the HCD Compare report AND review the CF connectivity
  Control Unit and Device numbers to poinpoint the changes
  Once identified, the target IODF should be changed
  to reflect the correct CU and Device numbers if the changes
  were not deliberate.
  ****************************************************************
  

Local fix

• Activate the configuration SOFT in the n-1 images and
  then HARD in the last.
  

Problem summary

Problem conclusion

Temporary fix

Comments

• info apar
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels