Memory installation and upgrade instructions - Netfinity 5100

Content

Installing memory modules

Adding memory to your server is an easy way to make programs run faster. You can increase the amount of memory in your server by installing options called memory-module kits. Each kit contains one industry-standard, dual-inline memory module (DIMM).

• The Netfinity 5100 server supports a minimum of 128MB and a maximum of 4GB of system memory.
• The system uses a noninterleaved memory configuration.
• The system comes with a DIMM installed on the system board in connector J23.
• Install additional DIMMs in connectors J21, J19, and J18, in that order. (See diagram below).
• Your Netfinity 5100 server supports 128MB, 256MB, 512MB, and 1GB DIMMs.
• Compatible memory option part numbers

How to install a DIMM:

1. Review the documentation that comes with your option.
2. Turn off the server and peripheral devices and disconnect all external cables and power cords; then, remove the cover.
3. Touch the static-protective package containing the DIMM to any unpainted metal surface on the server. Then, remove the DIMM from the package. Note: To avoid breaking the retaining clips or damaging the DIMM connectors, handle the clips gently.
4. Turn the DIMM so that the pins align correctly with the connector.
5. Insert the DIMM into the connector by pressing on one edge of the DIMM and then on the other edge of the DIMM. Be sure to press straight into the connector. Be sure that the retaining clips snap into the closed positions.
6. Make sure the retaining clips are in the closed position. If a gap exists between the DIMM and the retaining clips, the DIMM has not been properly installed. In this case, open the retaining clips and remove the DIMM; then, reinsert the DIMM.
7. If you have other options to install or remove, do so now; otherwise, reinstall the cover.
8. Installing or removing DIMMs changes the configuration information in the server. Therefore, after installing or removing a DIMM, you must save the new configuration information by using the Configuration/Setup Utility program. When you restart the server, the system displays a message indicating that the memory configuration has changed. Start the Configuration/Setup Utility program and select Save Settings, then exit the setup utility.
9. Installation is complete.

Netfinity 5100 Memory Installation Diagram: