Installing memory - Netfinity 5100

Resolving The Problem

You can increase the amount of memory in the server by installing options called memory-module kits. Each kit contains one industry-standard, dual-inline memory module (DIMM). The server uses a noninterleaved memory configuration. The server comes with a DIMM installed on the system board in connector J23.

Notes:

1. Install additional DIMMs in connectors J21, J19, and J18, in that order.
2. The Netfinity 5100 server supports 128MB, 256MB, 512MB, and 1GB DIMMs. The server supports a minimum of 128MB and a maximum of 4GB of system memory.
3. Installing or removing DIMMs changes the configuration information in the server. Therefore, after installing or removing a DIMM, you must save the new configuration information by using the Configuration/Setup Utility program. When you restart the server, the system displays a message indicating that the memory configuration has changed. Press F1 to access the Configuration/Setup Utility program and select Save Settings.
   
   
   

1. DIMM 2
2. DIMM connector 4 (J18)
3. DIMM connector 3 (J19)
4. DIMM connector 2 (J21)
5. DIMM connector 1 (J23)
6. DIMM 1

Installing a DIMM

1. Review the documentation that comes with the option.
2. Turn off the server and peripheral devices and disconnect all external cables and power cords; then, remove the cover.
3. Touch the static-protective package containing the DIMM to any unpainted metal surface on the server. Then, remove the DIMM from the package.
   
   Note: To avoid breaking the retaining clips or damaging the DIMM connectors, handle the clips gently.
   
   
4. Install the DIMM:
   1. Turn the DIMM so that the pins align correctly with the connector.
   2. Insert the DIMM into the connector by pressing on one edge of the DIMM and then on the other edge of the DIMM. Be sure to press straight into the connector. Be sure that the retaining clips snap into the closed positions.
   3. Make sure the retaining clips are in the closed position. If a gap exists between the DIMM and the retaining clips, the DIMM has not been properly installed. In this case, open the retaining clips and remove the DIMM; then, reinsert the DIMM.
      
      
5. Install any other options.
6. Replace cover.