Product Documentation
Abstract
This guide describes how to install and manage standard and MetroCluster™ active/active configurations, including storage in an active/active configuration and MetroCluster disaster recovery, using IBM® System Storage™ N series storage systems that run the Data ONTAP® 7.3 release family software. This guide also applies to gateway systems that support active/active configurations, unless you see a note indicating that you should refer to the gateway documentation.
Content
This guide describes the following tasks and topics:
- About this guide
- Active/active configuration types and requirements
- Active/active configuration installation
- MetroCluster installation
- Reconfiguring an active/active configuration into two stand-alone systems
- Configuring an active/active configuration
- Managing takeover and giveback
- Managing EXN1000, EXN2000, or EXN4000 units in an active/active configuration
- Disaster recovery using MetroCluster
- Nondisruptive operations with active/active configurations
- Controller failover and single-points-of-failure
- Feature update record
- Abbreviations
Publication Number
GC27-2208-08
Data ONTAP 7.3 Active/Active Configuration Guide
[{"Product":{"code":"nseries","label":"IBM System Storage N series"},"Business Unit":{"code":"BU058","label":"IBM Infrastructure w\/TPS"},"Component":"Not Applicable","Platform":[{"code":"","label":"Data ONTAP"}],"Version":"7.3.6;7.3.5;7.3.2;7.3.1;7.3","Edition":"","Line of Business":{"code":"LOB26","label":"Storage"}}]
Was this topic helpful?
Document Information
Modified date:
15 December 2021
UID
ssg1S7002467