IBM Support

IBM Netfinity 5600 - System board diagram

Product Documentation


Abstract

This document contains a diagram of the system board of the Netfinity 5600 server.

Content

System board component locations
 The following illustration shows a layout of the system board and identifies system board components. You might need to refer to this figure before you install hardware in the server. You might also need to refer to this figure when you set configuration jumpers on the system board.

System board component locations

  1. Dual serial and PCI hot-plug control switch connector (J1)
  2. Microprocessor board connector (J4, J8)
  3. Operator information panel connector (J29)
  4. Reserved (J32)
  5. Reserved (J10)
  6. Diskette drive connector (J23)
  7. Diagnostic LED panel connector (J6)
  8. Reserved (J17)
  9. Internal LVD (low voltage differential) SCSI connector (J25) (with extender cable on bracket)
  10. PCI slots 1 and 2 (on primary PCI bus A)
  11. IDE connector (J27)
  12. Power control and reset panel cable connector (J18)
  13. Advanced System Management Interconnect connector (J35)
  14. Battery
  15. PCI (hot-plug) slots 3–5 (on primary PCI bus B)
  16. Jumper block (J20)
  17. PCI slot Power Good LEDs
  18. Internal PCI slot Attention LEDs
  19. External PCI slot Attention LEDs
  20. Advanced System Management adapter connector (J21)
  21. External LVD SCSI/Parallel port connectors (J19)
  22. Serial/video port connectors (J11)
  23. USB 1 and USB 2 port connectors (J9) (USB 2 is below USB 1.)
  24. Ethernet port connector (J7)
  25. Mouse and keyboard connectors (J5) (The mouse connector is above the keyboard connector.)

System board jumpers
The following table describes the jumpers on the system board. The numbers in the table correspond to the highlighted numbers on the illustration in System board component locations.

NOTE: Turn off the server and disconnect the power cords before moving any jumpers.

The following illustration shows pin positions for the system board jumper J20. Pin 1 is the pin at the upper-left corner of J20 in the illustration of the system board in System board component locations.

Pin positions for the system board jumper J20

Jumper pin positions Description
Pins 1–3 (N/A) The default is no jumper on pins 1 , 2, and 3.
Pins 4–6 (N/A) The default is a jumper on pins 5 and 6.
Pins 7–9 The default is a jumper on pins 8 and 9 ASM enabled (pins 7-8 ASM disabled).
Pins 10–12 (N/A) The default is a jumper on pins 10 and 11

Additional information
Netfinity 5600 - System parts listing
Netfinity 5600 - Hardware Maintenance Manual

Document Location

Worldwide

Operating System

Older System x:Operating system independent / None

[{"Type":"HW","Business Unit":{"code":"BU016","label":"Multiple Vendor Support"},"Product":{"code":"HWN08","label":"Older System x->Netfinity 5600"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Line of Business":{"code":"","label":""}}]

Document Information

Modified date:
24 January 2019

UID

ibm1MIGR-52749

Page Feedback