IBM Support

DELL - PowerEdge R730 - Memory Modules - Installing and removing.

How To


Summary

How to Install / Remove a Memory Modules.

Steps

Removing Memory Modules

Before You Begin

⚠️ Important: Only perform basic troubleshooting or component replacement if it's explicitly allowed in your product documentation or advised by official support. Unauthorized servicing may void your warranty.

  1. Review and adhere to all safety instructions included with your system.
  2. Follow the guidelines outlined in the Before working inside your system section.
  3. Detach the cooling shroud.
  4. If present, remove the cooling fan assembly.
  5. If applicable, remove the 165 W heat sink.

🔎 Note: Memory modules may remain hot for a while after shutdown. Allow them to cool before handling. Always hold modules by their edges, avoiding contact with components or connectors.

⚠️ Caution: Empty memory slots must be filled with blanks to maintain proper airflow. Only remove blanks if you're installing memory in that slot.

Procedure

  1. Identify the memory slot from which the module will be removed.
  2. Carefully press the release tabs on both sides of the slot to disengage the module.
  3. Gently lift the module out, holding it by the edges.

After Removal

  • If you're not replacing the module, insert a blank into the empty slot.
  • Reinstall the cooling shroud.
  • If removed earlier, reinstall the 165 W heat sink.
  • Complete the steps in the After working inside your system section.

Installing Memory Modules

Before You Begin

🔎 Note: Let memory modules cool before handling if the system was recently powered off. Handle modules by the edges only.

⚠️ Important: Only proceed with installation if it's permitted by your documentation or support team. Unauthorized work may void your warranty.

  1. Review all safety instructions provided with your system.
  2. Follow the steps in the Before working inside your system section.
  3. Remove the cooling fan assembly if present.
  4. Detach the 165 W heat sink if installed.
  5. Remove the cooling shroud.

Installation Steps

  1. Locate the correct memory slot.
  2. Open the ejector clips on both sides of the slot.
  3. Align the module’s edge connector with the slot’s keying notch.
  4. Insert the module firmly, applying even pressure on both ends.
  5. Ensure the ejector clips snap into place, indicating proper seating.

⚠️ Caution: Do not press on the center of the module. Use both ends to apply pressure evenly.

🔎 Note: The slot design ensures the module fits only in the correct orientation.

After Installation

  • Reattach the cooling shroud.
  • Reinstall the 165 W heat sink if it was removed.
  • Follow the steps in the After working inside your system section.
  • Power on the system and press F2 to enter the BIOS/UEFI setup.
  • Verify that the memory is correctly recognized.
  • If the memory count is incorrect, reseat the modules.
  • Run the system’s built-in memory diagnostics to confirm functionality.

Document Location

Worldwide

[{"Type":"MASTER","Line of Business":{"code":"LOB66","label":"Technology Lifecycle Services"},"Business Unit":{"code":"BU058","label":"IBM Infrastructure w\/TPS"},"Product":{"code":"SSFBM70","label":"MVS Server - Dell"},"ARM Category":[{"code":"a8m3p000000PCUsAAO","label":"MVS Server-\u003EDell x86-\u003EPoweredge Rack-\u003E13-\u003ER730"}],"ARM Case Number":"","Platform":[{"code":"PF025","label":"Platform Independent"}]}]

Document Information

Modified date:
25 September 2025

UID

ibm17238829

Page Feedback