Controls - Netfinity 5000

Content

Tower Model


Rack Model

1. Diskette-eject button: Press this button to release a diskette from the diskette drive.
2. Diskette-drive in-use button: This light comes on when the diskette drive is accessed.
3. CD-ROM manual tray-release opening: Insert a straightened paper clip in the opening to release the CD-ROM tray when using the CD-ROM eject button.
4. CD-ROM eject button: Press this button to release a CD from the drive.
   NOTE: If the CD-ROM does not extend out, insert the end of a straightened paper clip into the manual tray-release opening then gently pull the tray open.
5. Reset button: Press this button to reset the server.
6. Power-on switch: Use this switch to turn on your server, or to return the server to "Standby mode" (power is present but the server is not turned on).
   NOTE: After you plug the server power cord into an outlet, wait 20 seconds before pressing the power switch. (During this time, the system-management processor is initializing and the power-on switch does not respond.)
   NOTE: If the CD-ROM does not extend out, insert the end of a straightened paper clip into the manual tray-release opening then gently pull the tray open. WARNING The Power-On button on the front of the server does not turn off the electrical current supplied to the server. The server also might have more than one power cord. To remove all electrical current from the server, ensure that all power cords are disconnected from the power source. The automatic restart feature, which enables the server to restart following a momentary power loss, means that the server is never completely turned off. Do not set the server to the Standby mode if any drive in-use light is on. This might damage the information stored on a hard disk drive or on a diskette. A Power-On Switch protector, which prevents the Power-On Switch from being pushed accidentally, is shipped with the server. To toggle the server between Standby mode and actively running, press and release the Power-On Switch.
7. Side-cover release lever: Use this lever to release the left-side cover.
8. CD-ROM drive in-use light: The light comes on when the CD-ROM drive is accessed.
9. Operator LED panel: This panel contains LEDs that light to indicate conditions on the server (such as power) or on a system error (see Front Panel Indicators ).