OA65387: LISTC LVL() OUTFILE() ALL ENDS WITH ABEND0C4 IN IDCTP01 UJ08761 AT X+20C8 WHEN USING IAM 24/11/07 PTF PECHANGE

Obtain the fix for this APAR.

APAR status

• Closed as program error.

Error description

• When issuing multiple LISTC LVL() OUTFILE() ALL commands in
  batch, ABEND0C4 IN IDCTP01 UJ08761 at x+20C8
  
  Note: In z/OS V2R5 DFSMS with APAR OA65387 applied and
  subsequent releases, the "LISTING FROM CATALOG -- catalog-name"
  message has been restored to each page header to the OUTFILE
  when running IDCAMS LISTCAT LVL command as it was pre-z/OS V2R5
  
  CATKEYS: IDC2023
  IDCABEND IDCLISTC
  
  ANALYSIS:
  IDCAMS trys to execute a MVC to the storage where REG3 points,
  to create the SUBTITLE Line for the LISTC output.
  
  KNOWN IMPACT:
  The BATCH JOB fails with ABEND0C4-4.
  
  VERIFICATION STEPS:
  Confirm that multiple LISTCAT LVL() OUTFILE() commands were
  issued in batch, and that the enviroment has IAM software
  active. Then via IPCS, verify that REG3 points to Key0 Storage,
  and that the PSW is in Key8.
  
  PE INFORMATION:
  USERS AFFECTED:
  APAR OA63298 (UJ08880) introduced a defect causing ABEND0C4 IN
  IDCTP01 UJ08761 at x+20C8, when issuing LISTC LVL() OUTFILE()
  
  
  USER IMPACT:
  APAR OA63298 fixed the problem it reported but introduced a new
  problem.
  

Local fix

• BYPASS/CIRCUMVENTION:
  Remove UJ08880, steplib to a version of IDCAMS without UJ08880,
  

Problem summary

• ****************************************************************
  * USERS AFFECTED: All users of IDCAMS LISTCAT LEVEL release    *
  *                 z/os level2,5 and higher issuing the         *
  *                 LITCAT via the Problem Program Interface     *
  ****************************************************************
  * PROBLEM DESCRIPTION: LISTC LVL() OUTFILE() ALL ENDS WITH     *
  *                      ABEND0C4 IN IDCTP01                     *
  ****************************************************************
  The 0C4 was caused by changes that called a needed procedure
  that got control blocks. The code is changed to add back in the
  calls to those procedures.
  

Problem conclusion

• The problem is fixed. Apply the maintenance and rerun.
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

  UJ96175 UJ96179

Modules/Macros

• IDCLC05  IDCLC09
  

Fix information

• Fixed component name

  ACCESS METHOD S

• Fixed component ID

  5695DF103

Applicable component levels

• R250 PSY UJ96179

     UP24/10/29 P F410

• R310 PSY UJ96175

     UP24/10/29 P F410

Fix is available

• Select the PTF appropriate for your component level. You will be required to sign in. Distribution on physical media is not available in all countries.