IT42565: SAP HANA REVERT FAILS WHEN THE SOURCE VOLUME IS CONFIGURED IN A HYPERSWAP RELATIONSHIP

APAR status

• Closed as Permanent restriction.

Error description

• IBM Spectrum Copy Data Management SAP HANA recovery job with the
  revert function enabled will fail if it is performing a revert
  on a source volume that is configured in an active-active
  relationship or HyperSwap relationship. The HyperSwap
  relationship has to be broken before a revert can run on the
  volumes.
  
  Affected versions: 2.2.x
  

Local fix

• The HyperSwap relationship has to be broken on the storage to
  run a SAP HANA recovery with the revert function enabled.
  

Problem summary

• ****************************************************************
  * USERS AFFECTED:                                              *
  * IBM Spectrum Copy Data Management level 2.2.10, 2.2.11.0,    *
  * 2.2.12.0, 2.2.13.0, 2.2.14.0, 2.2.15.0, 2.2.16.0, 2.2.17.0.  *
  ****************************************************************
  * PROBLEM DESCRIPTION:                                         *
  * see Error Description                                        *
  ****************************************************************
  * RECOMMENDATION:                                              *
  ****************************************************************
  

Problem conclusion

• The revert function is not supported for HyperSwap environments.
  This is a permanent restriction for IBM Spectrum Copy Data
  Management.
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels