II03731: TSO/E VERSION 2 RELEASE 1.0 INFORMATION APAR V210 V2R1

APAR status

• Closed as canceled.

Error description

• THIS IS THE INFORMATION APAR FOR TSO/E VERSION 2
  RELEASE 1.0.
  

Local fix

Problem summary

• 1) ESP PROGRAM DIRECTORY UPDATES:
     THIS UPDATE APPLIES ONLY TO  USERS WITH PROGRAM DIRECTORIES
     DISTRIBUTED VIA THE EARLY SUPPORT PROGRAM (ESP).
  
     THE PROGRAM DIRECTORIES HAVE THE FOLLOWING ORDER NUMBERS:
  
     TSO/E VERSION 2 RELEASE 1.0 XA ZES1-1038-0
           ( HTE21C2 )              GC28-1865-0 WITH AN ESP NOTE
                                                ABOVE THE NUMBER
  
     TSO/E VERSION 2 RELEASE 1.0 SA ZES1-1037-0
           ( HTE21D2 )              GC28-1871-0 WITH AN ESP NOTE
                                                ABOVE THE NUMBER.
  
     SECTION 3.2 PREVENTIVE SERVICE PLANNING STATES THE INCORRECT
     UPGRADE.  MVS038 IS NOT THE CORRECT UPGRADE.  THE BOX SHOULD
     READ:
         +-------------------+     +-------------------+
         | UPGRADE | SUBSET  |     | UPGRADE | SUBSET  |
         +---------+---------+     +---------+---------+
         | TSO210  | HTE21C2 | OR  | TSO210  | HTE21D2 |
         +---------+---------+     +---------+---------+
         | TSO210  | JTE21C0 |     | TSO210  | JTE21D0 |
         +-------------------+     +-------------------+
  
  2) REXX DEFAULT PARAMETER MODULES VALUES
        THE TSO/E VERSION 2 REXX REFERENCE (SC28-1883-0, SC281883)
     PROVIDES A TABLE OF THE DEFAULT VALUES IN THE THREE DEFAULT
     PARAMETER MODULES IRXPARMS, IRXTSPRM, AND IRXISPRM.  THIS IS
     ON PAGE 299, FIGURE 47 (PART 1 OF 3).  THIS TABLE IS * NOT *
     A MAPPING OF THE FLAGS FIELD IN THE PARMBLOCK.  A MAPPING IS
     PROVIDED ON PAGE 278, FIGURE 41.  NOTE BIT POSITION NUMBER 1
     IS RESERVED.
        THEREFORE, THE DEFAULT SETTINGS FOR THE FLAGS FIELD ARE:
                IRXPARMS (MVS)      X'00008000'
                IRXTSPRM (TSO/E)    X'8000D000'
                IRXISPRM (ISPF)     X'81004000'
  3) MAIL AND NOTICES AT LOGON TIME:
     IF THERE IS NO LOGON PRE-PROMPT EXIT (IKJEFLD OR IKJEFLD1)
     INSTALLED ON THE SYSTEM, THE USER WILL RECEIVE MAIL UNLESS
     'NOMAIL' IS SPECIFIED ON THE LOGON COMMAND OR ON THE FULL-
     SCREEN LOGON PANEL.
     IF A LOGON PRE-PROMPT EXIT DOES EXIST ON THE SYSTEM,
     PROCESSING DEPENDS ON THE WAY THE "MAIL" BIT IS SET.  IF THE
     EXIT DOES NOT SET THE "MAIL" BIT TO 1 (THAT IS, THE "MAIL"
     BIT DEFAULTS TO 0), OR IF IT SETS THE "MAIL" BIT TO 0, THE
     USER WILL NOT RECEIVE MAIL UNLESS "MAIL" IS SPECIFIED ON THE
     LOGON COMMAND OR ON THE FULL-SCREEN LOGON PANEL.
     IF THE EXIT SETS THE "MAIL" BIT TO 1 THEN THE USER WILL
     RECEIVE MAIL UNLESS "NOMAIL" IS SPECIFIED ON THE LOGON
     COMMAND OR ON THE FULL-SCREEN LOGON PANEL.
     NOTE THAT IF THE EXIT SETS THE "NO PROMPT" BIT TO 1 THEN THE
     VALUE OF THE "MAIL" BIT IN THE EXIT ALONE DETERMINES WHETHER
     THE RECEIVES MAIL OR NOT.
     FOR NOTICES THE PROCESSING IS THE SAME AS THAT FOR MAIL.
  4) ABEND0C2 IN IKJCTIOR AT +X'B0':
     THIS ABEND MAY BE CAUSED BY A DOWN-LEVEL VERSION OF THE
     EXEC LOAD MODULE.  CHECK ANY LIBRARY THAT IS SEARCHED BEFORE
     CMDLIB FOR A DOWN-LEVEL LOAD MODULE OF EXEC, OR ANY ONE OF
     ITS ALIASES, IKJEXC2 OR EX.
     IGX00026 GIVES CONTROL TO IKJCT430.  IKJCT430 USED TO RUN IN
     KEY 8.  NOW WITH VERSION 2 RELEASE 1.0, IT RUNS IN KEY 1.
     IKJCTIOR DEPENDS ON GETTING CONTROL IN KEY 1, AND IF
     IKJCT430 IS FROM A PREVIOUS RELEASE, THE ABEND0C2 MAY RESULT.
  5) IKJCAFR RESULTS IN LOAD MODULE IKJCAF BEING NON-REENTERABLE:
     IKJCAFR DOES NOT HAVE A LINK EDIT ATTRIBUTE OF REENTERABLE
     ( RENT ).  THIS RESULTS IN THE LOAD MODULE IKJCAF BEING
     MARKED NORENT.  HOWEVER, SINCE LOAD MODULE IKJCAF RESIDES
     IN LPALIB, PROCESSING IS NOT AFFECTED.  THE LOAD MODULE IS
     ESSENTIALLY REENTERABLE.
  

Problem conclusion

Temporary fix

Comments

• THIS IS THE INFORMATION APAR FOR TSO/E VERSION 2
  RELEASE 1.0.
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels