HE11315: Wrong extremity Line when defining Flatness, Profile-of-Line or Profile-of-Surface Tolerance with common zone

APAR status

• Closed as program error.

Error description

• This problem does no longer occur on CXR21rel, but the customer
  has reported this as priority 1 so we need
  to create a fix on reported level.
  Scenario tested on CRX20rel NOK
  Scenario tested on CRX21rel  OK.
  .
  1. Start Catia V5
  2. Open xxxxx.CATPart
  3. Start FT&A Workbench
  4. Start Tolerancing Advisor
  5. Select two or more of the green surfaces
  6. Select Icon Flatness Specification
  Please notice: two of the generated extremity lines are pointing
   to the same surface. The last selected surface is not pointed b
  y an extremity line.
  .
  Please notice:
  The same error occurs when defining Profile-of-Line or Profile-o
  f-Surface Tolerance with common zone.
  .
  Expected result:
  If 2 planes are selected, extremity lines should point to both p
  lanes
  

Local fix

• empty
  

Problem summary

• This problem does no longer occur on CXR21rel, but the
  customer has reported this as priority 1 so we need
  to create a fix on reported level.
  Scenario tested on CRX20rel NOK
  Scenario tested on CRX21rel  OK.
  .
  1. Start Catia V5
  2. Open xxxxx.CATPart
  3. Start FT&A Workbench
  4. Start Tolerancing Advisor
  5. Select two or more of the green surfaces
  6. Select Icon Flatness Specification
  Please notice: two of the generated extremity lines are
  pointing to the same surface. The last selected surface is
  not pointed by an extremity line.
  .
  Please notice:
  The same error occurs when defining Profile-of-Line or
  Profile-of-Surface Tolerance with common zone.
  .
  Expected result:
  If 2 planes are selected, extremity lines should point to
  both planes
  

Problem conclusion

• NOTE THAT THIS PROBLEM WILL ALSO BE FIXED ON V5R20 SP7.
  NOTE THAT THIS PROBLEM WILL ALSO BE FIXED ON V5R21 SP2.
  Additional Closure Information:
  Technical explanation of the defect:
  Wrong extremity Line when defining Flatness, Profile-of-Line
  or Profile-of-Surface Tolerance with common zone.
  Technical explanation of the correction:
  When the leader is associative to geometry(perpendicular to
  leader) the anchor point
  of the leader should be the middle point and not the middle
  point of the previous leader so that
  the leaders are correctly aligned. Its fixed now.
  Possible by-pass or correction limitation: None
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 WIN 64

• Fixed component ID

  569165000

Applicable component levels

• R520 PSN

     UP